![]() ![]() I migrated Hjalmar's project to a ChipKit Max 32 board (32-bit chip, 80 MHz clock). It will be very simple for others to download the software to an Arduino and have fun with your project. ![]() I need to optimize the tone frequency and level (at 600 Hz my input signal is only 1.6Vp-p) and see to what speed I have perfect decoding when the input is "perfect". With the "perfect" CW input from a test message sent by the keyboard, I have perfect decoding up to 30 wpm. Neither is as close to your 558 Hz or 744 Hz frequencies, and I expect it will work even better when optimized and with a higher input amplitude. At 600 Hz, my output p-p level does not drop as low as at 750 Hz but neither 600 or 750 is optimum. I can vary my tone from roughly 600 Hz to 750 Hz. So my output amplitude peaks near that QRG. This is a preliminary test because I use a Hi-Per Mite filter on my sidetone, centered around 648 Hz. I used a "pure" sinewave sidetone from another keyer as the CW test source. I converted one of my keyers (that already had the LCD interfaced to a ATmega328P chip) to try it out. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |